Mitee-Bite Machinable Fixture Clamps

Machinable Fixture Clamps

These clamps, with the machinable steel washers, provide more flexibility for holding round or unusual shaped parts. Parts can be held directly to the fixture plate surface or elevated for through-drilling. A special screw is provided with each package to hold the washer in the proper place during machining. The flat edge is the same location as our original fixture clamp. It can be used where a stronger clamping surface is required.

– Low profile

– Made of mild steel for machinability

Inch

Part No.	A	B	C	D	E	F	G*	H†	Max Torque (ft/lbs)	Holding Force	Clamps per pack	Replacement Cam Screw	Replacement Washer
10504	1/4 – 20	1/8	.040	.980	.250	.470	.250	.308	6.2	800 lbs	4	10365	10604
10506	3/8 – 16	3/16	.050	1.230	.350	.710	.275	.400	20.8	2,000 lbs	4	10371	10606
10508	1/2 – 13	5/16	.100	1.480	.450	.900	.300	.500	65.0	4,000 lbs	4	10373	10608
10510	5/8 – 11	3/8	.100	1.730	.550	1.125	.350	.590	100.0	6,000 lbs	4	10375	10610

G* – amount of machinable stock.
H† – the distance to drill & tap hole from edge of workpiece to use flat face.
Every package includes one machining screw.

Metric

Part No.	A	B	C	D	E	F	G*	H†	Max Torque (N.m.)	Holding Force	Clamps per pack	Replacement Cam Screw	Replacement Washer
50506	M6	4M	1.01	24.9	6.4	11.9	6.4	7.8mm	8.50	3358 N.	4	50365	10604
50510	M10	7M	1.52	31.2	8.9	18.0	7.0	10.2mm	28.00	8900 N.	4	50369	10606
50512	M12	8M	2.03	37.6	11.4	22.9	7.6	12.7mm	88.00	17800 N.	4	50371	10612
50516	M16	12M	2.54	43.9	14.0	28.6	8.9	15.0mm	135.00	26700 N.	4	50373	10610

G* – the amount of machinable stock.
H† – the distance to drill & tap hole from edge of workpiece to use flat face.
Every package includes one machining screw.