Mitee-Bite Compact Toe Clamps

Measurements Available: Inch, Metric

Compact Toe Clamps

This cam action fixture clamp provides positive down force while using very little space on a fixture. Work pieces can be clamped in series by using the back surface of a clamp to locate the next work piece.

The hardened steel clamping element has both a smooth surface for machined work pieces and a serrated clamping surface for rougher work. The height of the clamp can be adjusted by milling the slot deeper in the fixture plate.

Inch

Part No.	A	B	C	D	E†	F	G	H	I*	Cam Screw	Total Distance of Movement	Mounting Screws (Included)	Torque (ft/lbs)	Holding Force (lbs)	Replacement Square Washer
24106	1.70	.75	.50	1.00	.090	.75	.25	.62	.845	10370	.050	5/16 – 18 x 3/4 LHCS	20.8	2000	21006
24108	2.12	1.00	.45	1.32	.110	1.00	.38	.62	.960	10372	.100	3/8 – 16 x 3/4 LHCS	65.0	4000	21016
24110	2.95	1.50	.99	2.00	.130	1.50	.50	1.25	1.70	10376	.100	1/2 – 13 x 1 1/4 SHCS	100.0	6000	21026

E† – The distance needed between the front of the clamp base and the work piece
I* – The distance from the top of the washer to the bottom of the clamp body.
Drill and tap the centerline of “B” for mounting holes.

Metric

Part No.	A	B	C	D	E†	F	G	H	I*	Cam Screw	Total Distance of Movement	Mounting Screws (Included)	Torque (N.m.)	Holding Force (N.)	Replacement Square Washer
54110	43.2	19.0	12.7	25.4	2.3	19.0	6.4	15.75	21.5	50368	1.6	M8x16 LHCS	28.20	8900	21006
54112	54.0	25.4	11.4	33.5	2.8	25.4	9.7	15.75	24.4	50372	2.0	M10x20 LHCS	88.13	17800	51016
54116	75.0	38.1	25.2	50.8	3.3	38.1	12.7	31.75	43.2	50374	2.5	M12x30 SHCS	135.58	26700	21026

E† is the distance needed between the front of the clamp base and the work piece.
I* The distance from the top of the washer to the bottom of the clamp body.
Drill and tap the centerline of “B” for mounting holes.